Enabling Infrastructure; Setting The Ip Address - Oki COREFIDO B822dn User Manual

7
Press ▼ to select [Wireless], and press «OK».
8
When [Are You Sure?] is displayed, check that [Yes] is selected, and press «OK».
9
Wait until the standby screen appears as this machine restarts.
If [Not connected to wireless access point] is displayed, press «OK».
If [Set-up wireless?] is displayed, select [No], and then press «OK».

2. Enabling infrastructure

1
Press the scroll button ▼ on the operator panel several times to select [Wireless(Infrastructure)
Setting], and press «OK».
2
Press ▲ or ▼ to input the admin password, and press «OK».
Admin Password(P.207)
"It is not possible to use the Wireless(AP Mode) at the same time." will be displayed for about 5 seconds.
3
Press ▲ to select [Enable], and press «OK».
After setting wireless(AP Mode) to [Disable], if a screen appears to ask you to check whether to enable
wireless(Infrastructure), press «OK» to enable wireless (Infrastructure).
To set the IP address of this machine manually, go to "
To obtain an IP address automatically, go to "
 The factory default setting is [Auto].

3. Setting the IP address

If you want to set the machine's IP address to a fixed value, follow the procedure below.
 For [Auto], the machine's IP address may change dynamically.
 For [IPv4 Address], set a value which is not overlapped to any other networked machines.
 If you do not use the IPv6 address, set [DHCPv6] to [Disable].
Preparing and connecting this machine to your PC
3. Setting the IP address
4. Connecting with the wireless access point
- 53 -
(P.53)".
(P.56)".