Service Life And Replacement Cycle Of Maintenance Parts; Maintenance Kit - Oki COREFIDO B822dn User Manual

Service life and replacement cycle of maintenance parts

The maintenance part is the target product of COREFIDO free maintenance parts service.

Maintenance kit

The maintenance kit is a set of a fuser and a transfer roller.
Service life of the maintenance kit
The fuser unit and the transfer roller can print approximately 120,000 sheets of A4-sized paper (fed in
landscape for simplex printing), but the actual printable number of sheets may vary with the usage condition.
The above number is based on the general usage condition (three sheets at a time). If you print a single sheet
at a time, the life may be reduced by half.
A message appears indicating preparation for replacement when the end of life is approaching.
To check the life of the fuser, select [Functions] - [Configuration] - [Supplies Status] - [Fuser] on the operator
panel.
For Windows, when you are using the Monitoring Tool, the Monitoring Tool will pop up a message to notify you
that it is time to replace the maintenance kit.
Monitoring Tool (Windows)(P.258)
Replacement cycle of the maintenance kit
When the time for replacement is approaching or has arrived, the following message appears on the display.
Fuser Near Life.
Displayed message
Prepare a new fuser.
Response to the
message
Printing is possible, but the fuser is
State of this machine
approaching the end of its service life.
About 2,500 pages can be printed from when the time for replacement is approaching to when the time for
replacement has arrived. (When printing under general usage conditions with factory default settings)
 If [Admin Setup] - [Panel Setup] - [Near Life Status] is set to [Disable], a message indicating the time for replacement
will not be displayed.
 You can change the timing for displaying a message indicating the time for replacement of the fuser. The factory
default setting is [2500].
This timing is set from [Admin Setup] - [Others Setup] - [Near Life Setup] - [Fuser Near Life Timing] on the operator
panel.
The setting range is from 500 to 5,000 (in increments of 500).
Replacing the maintenance
When the time for replacement is
approaching
kit(P.328)
When the time for replacement has
→
Fuser Life. Change Fuser.
→
Replace With A New Fuser Unit.
→
Printing is possible, but the print quality
→
cannot be guaranteed.
- 326 -
Maintenance
arrived