Installing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If removed, install the expansion cards into the expansion card risers.
Steps
1. Holding the blue touch points on the expansion card riser, align the expansion card with the connector on the system board.
2. Lower the expansion card riser into place until the expansion card riser is fully seated with the connector on the system
board.
Figure 52. Installing the riser
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. Remove the
expansion card
5. If applicable, disconnect the cables from the expansion card.
Steps
1. Turn-over the expansion card riser, and holding the expansion card by its edges, remove the card from the riser.
58
Installing and removing system components
Safety
instructions.
Before working inside your
After working inside the
Safety
instructions.
Before working inside your
riser.
system.
system.
system.