Table of Contents
Advertisement
Figure 44. Installing the heat sink onto the processor
Next steps
1
Install the processor and heat sink module.
2
Install the air shroud.
3
Follow the procedure listed in
Installing a processor and heat sink module
Prerequisites
CAUTION:
Never remove the heat sink from a processor unless you intend to replace the processor. The heat sink is necessary to
maintain proper thermal conditions.
1
Follow the safety guidelines listed in
2
If installed, remove the processor blank and CPU dust cover.
Steps
1
Align the pin 1 indicator of the heat sink to the system board and then place the processor and heat sink module (PHM) on the
processor socket.
CAUTION:
To avoid damaging the fins on the heat sink, do not press down on the heat sink
fins.
NOTE:
Ensure that the PHM is held parallel to the system board to prevent damaging the components.
2
Push the blue retention clips inward to allow the heat sink to drop into place.
3
Using the Torx #T30 screwdriver, tighten the screws on the heat sink in the order below:
a
Partially tighten the first screw (approximately 3 turns).
After working inside your
system.
Safety
instructions.
Installing and removing system components
99
Advertisement
Table of Contents
