Table of Contents
Advertisement
Figure 110. Installing the system board
Next steps
1
Replace the following:
a
Trusted Platform Module (TPM)
b
Integrated storage controller card
c
Internal USB key (if applicable)
d
USB 3.0 module (if applicable)
e
Internal USB key (if applicable)
f
All expansion cards and risers
g
Processors and heat sink modules
h
Processors blanks (if applicable)
i
Memory modules
j
Network daughter card
k
Air shroud
2
Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3
Follow the procedure listed in
4
Ensure that you:
a
Use the Easy Restore feature to restore the Service Tag For more information, see the
Easy Restore
feature section.
b
If the Service Tag is not backed up in the backup flash device,
c
Update the BIOS and iDRAC versions.
d
Re-enable the Trusted Platform Module (TPM). For more information, see the
5
Import your new or existing iDRAC Enterprise license.
For more information, see Integrated Dell Remote Access Controller User's Guide, at Dell.com/poweredgemanuals.
160
Installing and removing system components
and memory module blanks
After working inside your
system.
enter the Service Tag
Restoring the Service Tag by using the
manually.
Upgrading the Trusted Platform Module
section.
Advertisement
Table of Contents
