Table of Contents
Advertisement
Figure 72. Installing the integrated storage controller card cable
Next steps
1
Install the air
shroud.
2
Follow the procedure listed in
Drives
Removing a drive blank
The procedure for removing 2.5 inch and 3.5 inch drive blanks is identical.
Prerequisites
1
Follow the safety guidelines listed in
2
If installed,
remove the front bezel.
CAUTION:
To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Press the release button, and slide the drive blank out of the drive slot.
After working inside your
system.
Safety
instructions.
Installing and removing system components
125
Advertisement
Table of Contents
