Table of Contents
Advertisement
Figure 68. Installing the network daughter card
Next steps
1
Install the expansion card riser 2 or the rear drive cage, depending on the configuration of your system.
2
Follow the procedure listed in
Integrated storage controller card
Removing the integrated storage controller card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the air
shroud.
Steps
1
Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the connector on the system
board.
2
Lift the integrated storage controller cable to disconnect it from the connector on the system board.
122
Installing and removing system components
After working inside your
system.
Safety
instructions.
After working inside your
system.
Advertisement
Table of Contents
