Table of Contents
Advertisement
139647_29 GF 370 DV II IPI 10/23
Tumbled Stones
Install the stones according to the instructions supplied
with that kit.
Install the Log Set
The three-piece log set includes a bag of ember stones
that simulate glowing coals when the burner is operat-
ing.
Use workgloves and handle the individual logs
carefully, supporting each with both hands. Install the
Logset and Ember Stones as shown in figures 28-31.
PN 223286
Figure 28. Engage the Center Log with the two center
pins in the burner plate.
PN 223287
Figure 29. Lean the Right Log up against the upper right
corner of the firebox and engage the slot on the tip with
the pin on the Bottom Log.
20
Figure 30. Engage the narrow end of the Left Log with
the rear burner plate pin and lean it against the back
wall.
Figure 31.
Evenly disperse the Ember Stones over the burner
plate around the log parts. DO NOT ALLOW EMBER
STONES TO BLOCK THE PILOT ASSEMBLY AREA.
The carry-over ports directly in front of the pilot must
remain clear for proper pilot ignition.
Replace the Glass Frame
NEVER USE A POWER TOOL TO TIGHTEN GLASS FRAME
HARDWARE. Use the 4 mm hex key provided to secure
screws. Wear clean cut resistant gloves when handling
theglass and glass frame.
Use the following procedure to ensure correct glass
frame replacement:
1) Use a clean cloth to wipe away any dust or finger
prints from glass.
2) Hold the glass frame to firebox front with holes in
alignment where socket head screws were removed.
Advertisement
Table of Contents
