Table of Contents
Advertisement
8. Engage the hole at the lower end of the Right
Vertical log (#6) with pin "E" on the Adaptor
plate.
Rest the upper end again st the depression on
the log #5 as shown.
Replace the Glass Frame
NEVER USE A POWER TOOL TO TIGHTEN GLASS
FRAME HARDWARE. Use the 4 mm hex key provided
to secure screws. Wear clean cut resistant gloves when
handling theglass and glass frame.
Use the following procedure to ensure correct glass frame
replacement:
1) Use a clean cloth to wipe away any dust or finger prints
from glass. Do NOT use ammonia based glass cleaner.
2) Hold the glass frame to firebox front with holes in
alignment where socket head screws were removed.
3) Replace the socket head screws into glass frame finger
tight. Readjust screws to ensure glass frame alignment.
Take care not to cross thread screws.
4) Tighten screws in the following sequence to avoid plac-
ing uneven pressure on the glass:
1) Upper left
2) Lower right
3) Upper right
4) Lower left
139647_29 GF 370 DV II IPI 10/23
33
Advertisement
Table of Contents
