Log Set Installation - Jøtul GF 500 DV IPI Installation And Operation Instructions Manual

Log Set Installation

Brick Kit Note: Install the optional Brick Panel Kit 157697
before installing the log set. See page 22 or the instruc-
tions provided with that kit.
The GF 500 DV IPI log set must be installed before
operating the burner. The log set includes six log pieces,
packaged inside the firebox. Place the logs inside the
firebox as illustrated in figs. 45-46.
A quantity of ember stones is included with the
log set. These may be used as filler on the steel shelves
at each side of the burner base if the optional brick
panels are not installed. DO NOT PLACE EMBERS ON THE
BURNER BASE ITSELF.
Use a toothbrush or tweezers to sparingly place
pinches of rock wool over the front of the burner base.
BE SURE TO KEEP THE PILOT CARRY-OVER PORTS CLEAR OF
OBSTRUCTIONS. SEE FIG. 47.
WEAR GLOVES AND HANDLE THE LOG PARTS CAREFULLY.
#157706 Log Set Identification
#1 Rear Log
#2 Lower Left Log
#3 Lower Right Log
#4 Upper Left Log
#5 Upper Right Log
#6 Small Front Log
2
Figure 45 Set the Rear, Lower Left, and Lower Right logs
onto the burner base as shown.
4
Figure 46. Set the Upper Left, Upper Right, Front logs into
place.
Figure 47. Use caution in placing the logs to ensure that the
pilot carry-over ports are not obstructed.
139636 GF 500 DV IPI 7/28/14
1
3
5
6
25