Table of Contents
Advertisement
139647_29 GF 370 DV II IPI 10/23
SMART Thermostat Function
This function adjusts the flame intensity according to
the difference in the Set Point temperature and the
actual room temperature. As the room temperature gets
closer to the Set Point, the Smart Function will modulate
flame intensity down.
To activate this function, press the Thermostat Key
until the woed "SMART" appears to the right of the
thermometer bulb icon. Fig. 50.
To adjust the temperature, press the Up or Down
Arrow Keys until the desired Set Temperature is dis-
played. Fig. 51.
Fan Speed Control
Fan speed can be adjusted through six settings. To
activate this function, press the Mode Key (Fig. 40) to
index to the Fan Control icon. See fig. 52.
Use the Up/Down Arrow Keys to turn ON, OFF, or
adjust the fan speed. Fig. 53. A single "beep" will
confirm reception of the command.
Accent Lamp Control ( Auxiliary 120V
Outlet)
The auxiliary function controls the Accent Lamp
power. Press the Mode Key to index to the AUX icon.
Figs. 54-55.
Pressing the Up Arrow Key will turn the Lamp ON.
Lamp brightness can be adjusted by turning the dim-
mer knob on the stove Control Panel.
Pressing the Down Arrow Key will turn the Lamp OFF.
Child Safety Lock
This function will lockout the Transmitter to prevent
unsupervised operation.
To activate the Lock, press the Mode key and UP Key
at the same time. Fig. 56.
To de-activate the Lock, press the Mode Key and UP
Key at the same time.
Low Battery Detection
The life-span of the batteries depends on various fac-
tors; battery quality, the frequency of ignition calls, the
frequency of changes to Set Points, etc.
When Transmitter batteries are low, the Battery icon
will be displayed before all battery power is lost. The
icon will disappear when new batteries are installed.
When Receiver batteries are low, no "beep" will be
emitted from the Receiver when it receives an On/Off
command from the Transmitter. This is an alert for a
low battery condition in the Receiver. When the bat-
teries are replaced, the "beep" will be emitted from
26
Figure 50. Smart Mode
Figure 52. Fan Mode
Figure 54. Lamp Control
Figure 56. Lock ON
the Receiver when the ON/OFF Key is pressed. See
Battery Replacement under the Maintenance section
of this manual.
Manual By-Pass of the Remote System
When battery power is low or depleted, the burner can
still be operated manually by sliding the Receiver switch
to the ON position. It will immediately ignite in the High
position.
In the event of a power failure, flame modulation,
themostatic control, fan and lamp functions will be
unavailable. It is therefore advisable to keep a supply of
good quality batteries on hand.
Figure 51. Smart Set Temp.
Figure 53. Fan Speed
Figure 55.. Lamp ON
Figure 57. Low Battery
Advertisement
Table of Contents
