Table of Contents
Advertisement
Panel Retainer
Paint edge of side panels to
Figure 25. Loosen the panel retainer screws.
Rear Glass Panel
Figure 26. Install Rear Glass Panel.
Figure 26a. Install Side Glass Panels.
Upper
Bracket
match black glass.
8. Install Burner Media
River Rocks
CAUTION: THE ROCKS ARE FRAGILE! SUPPORT THE
ASSEMBLY FROM THE BOTTOM AND HANDLE CARE-
FULLY!
1. Engage the River Rock bed with the two center
burner pins as shown in fig. 27. Either side of the
rocks may face outward as desired.
2. Evenly disperse the Ember Stones supplied over the
burner plate around the log parts. DO NOT ALLOW
EMBER STONES TO BLOCK THE PILOT ASSEMBLY
AREA. The carry-over ports directly in front of the
pilot must remain clear for proper pilot ignition. See
figs. 29 and 65 for examples.
StarFire Glass Embers
Do not use more than the four pounds (in two, 2 lb.
bags) of glass media provided. For best results, evenly
spread the contents of the bag over the entire burner
plate and rear skirt, mounding a crown toward the
center.
DO NOT COVER THE AREA IMMEDIATELY IN FRONT
OF THE PILOT ASSEMBLY. The carry-over ports directly
in front of the pilot assembly must be clear to ensure proper
pilot ignition. See fig. 66 page 34.
Figure 27. Set River Rock assembly on pins.
139647_29 GF 370 DV II IPI 10/23
19
Advertisement
Table of Contents
