Jøtul GF 370 DV II IPI Installation And Operation Instruction Manual page 25

Remote Transmitter Controls, cont'd.
Temperature Indication Display

W ith the transmitter in the OFF position, press the
Thermostat Key and the Mode Key at the same time.
The display screen will show the current room temper-
ature cycling between Farenheit and Celsius indica-
tors each time the keys are pressed simultaneously.
See fig. 42.
Turn on the Burner

Press the ON/OFF Key on the Transmitter.
The display will show all the active icons. At the same
time, the Receiver will activate the Pilot Ignitor. First
the pilot will ignite, followed shortly by the burner. A
single"beep" from the Receiver will confirm reception
of the command.
Turn off the Burner

Press the ON/OFF Key. The display will show only
the room temperature and icon. At the same time,
the Receiver will deactivate the call for heat and the
burner will shut down. Fig. 43. A single"beep" from
the Receiver will confirm reception of the command.
Remote Burner Control
There are six flame levels available.

With the system ON, and the burner flame level at
maximum, press the Down Arrow Key once to reduce
the flame height by one step. Each time the Down Key
is pressed, the flame will step down until the burner is
finally turned off. Fig. 44.

The Up Arrow Key will increase the flame height each
tim it is pressed. If the U Arrow Key is pressed while
the system is on but the flame is off, the flame will
come on in the High position. Figs. 45-47. A single
"beep" will confirm reception of the command.
Room Thermostat (Transmitter Operation)
The Remote Control can operate as a room themostat.
The themostat can be set to a desired temperature to
control the comfort level in a room.

To activate this function, press the Thermostat Key,
(Fig. 40.) The display will indicate that the room
thermostat is "ON" and the current Set Temperature is
now displayed. Fig. 48.

To adjust the Set Temperature, press the Up or Down
Arrow Keys until the desired Set Temperature is dis-
played. Fig.49.
Figure 42. Room temperature readings
Figure 43. Burner shut-down
Figure 44. Burner OFF.
Figure 46. Flame Level 5.
Set Temperature
Figure 48. Thermostat ON
139647_29 GF 370 DV II IPI 10/23
Figure 45. Flame Level 1.
Figure 47. Flame Level 6.
Room Temperature
Figure 49.
Change Set Temperature
25