Battery Replacement; Accent Lamp Replacement - Jøtul GF 370 DV II IPI Installation And Operation Instruction Manual

139647_29 GF 370 DV II IPI 10/23
Figure 59.
156833
Front Glass
Replacement
Kit includes
gasket and spare
retainer clips.

Battery Replacement

Battery life depends on many variables; the quality of
the batteries, frequency of remote use, and mode of
pilot operation. Keep a supply of good quality batteries
on hand to be assured of functional continuity in the
event of a power failure.
WARNING!
ALWAYS SHUT OFF THE GAS SUPPLY AND
DISCONNECT THE POWER CORD FROM HOUSE
CURRENT BEFORE REPLACING BATTERIES.
IFC Battery Replacement
A red LED on the IFC board indicates low battery
power.
1. Switch the Burner to OFF and disconnect power to
the stove.
2. Access the battery box from the left side of the
control compartment. It is directly behind the
control switch plate. See fig. 68, #27. Disengage
the box from the hook & loop tape and pull it out
of the compartment.
3. Slide the cover back, install four, 1.5v AA batteries
and replace the box, tucking the wire leads within
the compartment.
4. Reconnect power to the stove.
5. Re-initialize the Remote Control transmitter
following the instructions below.
28
Initializing the Remote Control
Each time you replace the batteries, you will need to
initialize communication between the Receiver and the
Transmitter.
1. Place the slider switch in the REMOTE position.
2. Insert the end of a paper clip into the hole marked
PRG on the Receiver cover. The Receiver will "beep"
three (3) times to indicate that it is ready to synchro-
nize with the Transmitter.
3. Install 3 AAA batteries in the Transmitter bay and
push the ON button. The Receiver will "beep" four
times to indicate the Transmitter's command is ac-
cepted and sets to the particular code of that Trans-
mitter. The system is now initialized.

Accent Lamp Replacement

Handle the replacement bulb with gloves. Skin oils
will cause the bulb to fail prematurely.
1. Remove the glass frame. See fig. 18.
2. Remove the two retainer screws with a short phillips
screwdriver. Pull the socket out of the housing.
3. Plug the new bulb into the socket and re-install the
assembly into the lamp housing.
4. Replace the glass frame using the 4 mm hex key and
socket head screws previously removed.
PN 222943 Bulb, 130V / 50W
Figure 60. Accent Lamp Replacement.