Log Set Installation - Jøtul GF 400 BV Sebago Installation And Operation Instructions Manual

Log Set Installation

Brick Kit Note: Install the optional Antique Brick Kit
155370 before installing the logset. See page 22 and the
instructions provided with that kit.
The GF 400 BV logset must be installed before
operating the burner. The logset includes five log pieces,
and a bag of ember stones packaged inside the firebox.
To install the log set, remove the packaging and place the
parts inside the firebox as illustrated in figures 20-24. Do
not handle the log set with your bare hands. Always wear
gloves to prevent skin irritation from the ceramic fibers.
The ember stones realistically simulate glowing
coals when the burner is operating. These should be
spread evenly over the burner plate and around the logs.
DO NOT OBSTRUCT THE PILOT ASSEMBLY OPENING. Do
not pile the embers against the burner skirt edges. See
fig. 24.
NOTE: You do not need to use all of the ember
stones. With experimentation, you will find the
arrangement and quantity of embers that works
best with your stove. Depending upon the char-
acteristics of your installation, it is possible that
too many ember stones can promote sooting on
the logs. Adjust the quantity of ember stones as
appropriate to maintain the best overall flame
picture and burner performance.
Figure 20. Engage the holes in the underside ot the Right
Log with the peg in the burner skirt.
Figure 21. Engage the holes in the underside ot the Rear
Log with the two pegs in the burner skirt.
PN 220647
PN 220645
PN 220646
Figure 22. Install Left Log
PN 220648
Figure 23. Install Left Middle Log
PN 220701
Figure 24. Install Top Log
Figure 24a. Position embers loosely and maintain 1/4"
clearance from the burner skirt edges.
138301_Rev_G 10.4.11
Pilot
Opening
DO NOT
OBSTRUCT
15