Receipt/Journal Paper; Inserted Slips And Forms - TransAct Ithaca 90PLUS Series Programmer's Manual

Programmer's Guide
Roll footage
Paper low indicator
Receipt paper out
3.4.3

Receipt/Journal Paper

Paper feed method
Paper feed pitch
Paper width
Roll diameter
Paper thickness at 25 C
Two-ply
Three-ply
Roll paper core
Typical roll footage
Two-ply
Three-ply
Paper low indicator
Receipt paper low
3.4.4

Inserted Slips and Forms

Paper width
Length
Paper thickness
11/07/05
PcOS Series 90PLUS
240 feet (7315.2 cm) typical
striping starts at approximately 8 - 10 feet (243.8 - 300.5 cm) from end of roll
Paper exhaust is sensed, and printing is prevented at end of roll.
friction feed
default, inch; can be set in units of
1/8
2.5, 3.0, or 3.25 inches (63.5, 76.2, or 82.6 mm)
3.5 inches (88.9 mm)
0.006 - 0.007 inch (0.15 - 0.18 mm)
0.009 - 0.0105 inch (0.23 - 0.27 mm)
inside diameter, 7/16 inch
110 feet (3352.8 cm)
70 feet (2133.6 cm)
striping starts at approximately 8 - 10 feet (243.8 - 300.5 cm) from end of roll
The paper level is sensed by software with an adjustable end of roll monitor that
prevents printing.
2.50 - 9.0 inches (63.5 - 228.6 mm)
3.375 - 11.0 inches (85.7 - 279.4 mm)
a. one sheet: 0.0035 - 0.016 inches (0.089 - 0.41 mm) at 25 C
b. combination of copy paper and carbon copy paper:
4 sheets maximum (one original and three copies)
c. maximum form thickness: 0.016 inches (0.41 mm) at 25 C
Rev Q
General Specifications
inch by software command
1/216
Page 9