Table of Contents
Advertisement
Procedure - Removing the M.2 Module
Follow above steps in reverse order to remove the M.2 Module.
5.3
Installing and removing M.2 NVMe/ SATA SSD
Requirements
• The device is disconnected from the power supply.
• The device is opened.
• A M.2 NVMe/SATA SSD that is approved for industrial applications.
• A T10 screwdriver
SIMATIC IPC327G
Operating Instructions, 09/2021, A5E51366275-AA
Expanding and assigning parameters to the device
5.3 Installing and removing M.2 NVMe/ SATA SSD
Unscrew either one set of the marked screws for fixing
the COM interface.
Remove the COM interface and its jumpers on the moth-
erboard.
Follow above steps to install the M.2 Module with an
additional interface-card on the X100 or X101 interfaces
slot.
Note: The cable length of the M.2 Module should not be
shorter than 100 mm and no longer than 200 mm.
Secure the additional interface-card in the position of the
COM interface with screws.
37
Advertisement
Table of Contents
