Procedure
1. Unlock the front door and open the right-front door.
2. Remove the top cover.
3. Disconnect the power supply and data cables.
4. Remove the highlighted five screws.
5. Lift the drive cage completely out of the device.
6.4.3
Installing the drive (HDD/SSD)
You can find information on the correct mounting location for 5.25" drives in a drive cage
under "Installation options for drive (Page 55)".
Requirement
• An original spare part, i.e. an "Assembly Kit HDD/SDD for 5.25" tray" approved for this
device.
• The device is fully disconnected from the line voltage, see "Switching off the device
(Page 44)".
• The device is open, see important information in "Open the device (Page 49)".
• The drive bay is taken out of the chassis.
• PH2 screwdriver
SIMATIC IPC RW-543A
Operating Instructions, 03/2023, A5E52332059-AA
Expanding and assigning parameters to the device
6.4 Drives (HDD/SSD)
57