Removing And Installing An Ssd With Mounting Plate From A Drive Cage - Siemens SIMATIC IPC647D Operating Instructions Manual

Expanding and assigning parameters to the device
6.6 Drives and storage media
6.6.8.2

Removing and installing an SSD with mounting plate from a drive cage

Requirement
● The device is fully disconnected from the mains voltage, see chapter "Switching off the
device (Page 51)".
● The drive cage has been removed, see chapter "Removing and installing drive cage
(Page 74)".
● The drive fan has been removed, see chapter "Removing and installing drive fans
(Page 75)".
● 1 T10 screwdriver
Procedure
Read the section "ESD guideline (Page 119)".
Removal
1. On both sides of the drive cage,
2. Pull out the mounting plate with the
3. Remove the marked screws.
4. Remove the mounting plate from the
5. Pull out the plug from the SSD.
Installation
To install the fan, follow the steps for removing it in reverse order. Use only the original
screws during installation.
82
loosen the two screws that secure
the mounting plate in the drive cage.
SSD from the drive cage in the
direction of the cables.
Do not pull on the cables.
SSD.
Operating Instructions, 01/2014, A5E32996306-AA
SIMATIC IPC647D