Protected Menus - Toro 03956 Operator's Manual

Protected Menus

Protect Settings
Acceleration
Blade Count
Mow Speed
Trans. Speed
Smart Power
Economy Mode
Height of cut (HOC)
F Reel RPM
R Reel RPM
Protected under Protected Menus—accessible only
by entering PIN
About
Menu Item
Model
SN
Machine-Controller Revision
InfoCenter Revision
CAN Bus
Allows a person authorized
by your company with the
PIN code to access protected
menus.
Allows the ability to change
the settings in the protected
settings.
Low, Medium, and High
settings control how quickly
the traction speed reacts when
you move the traction pedal.
Controls the number of blades
on the reel for reel speed.
Controls the maximum speed
while in mow (low range)
Controls the maximum speed
while in transport (high range)
Turns Smart Power on and off
When activated, the Economy
Mode lowers the engine
speed while mowing to reduce
noise and fuel consumption.
Reel speed settings 8 and 9
cannot be achieved when the
Economy Mode is active.
Controls the height of cut
(HOC) for determining the reel
speed.
Displays the calculated reel
speed position for the front
reels. The reels can also be
manually adjusted.
Displays the calculated reel
speed position for the rear
reels. The reels can also be
manually adjusted.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
Protected Menus
There are operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter.
To lock these settings, use the Protected Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
30
M , use the center button to
ENU
M and press the
ETTINGS ENU
48).
Figure 48
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 49A).
g028523