Table of Contents
Advertisement
Figure 49
3.
To enter the PIN code, press the center button
until the correct first digit appears, then press
the right button to move on to the next digit
(Figure
49B and
until the last digit is entered and press the right
button once more.
4.
Press the middle button to enter the PIN code
(Figure
49D).
Wait until the red indicator light of the InfoCenter
illuminates.
Note:
If the InfoCenter accepts the PIN code
and the protected menu is unlocked, the word
"PIN" displays in the upper right corner of the
screen.
Note:
Rotate the key switch to the O
then to the O
position locks the protected menu.
N
Viewing and Changing the
Protected Menu Settings
1.
In the Protected Menu, scroll down to Protect
Settings.
2.
To view and change the settings without entering
a PIN code , use the right button to change the
Protect Settings to O
3.
To view and change the settings with a PIN
code, use the left button to change the Protect
Settings to O
, set the PIN code, and turn the
N
key in the ignition switch to the O
then to the O
position.
N
Figure
49C). Repeat this step
position and
FF
.
FF
position and
FF
Setting the Service Due Timer
The service due timer resets the service due
hours after a scheduled maintenance procedure is
performed.
1.
In the Settings Menu, use the center button to
scroll down to the P
the right button.
2.
Enter PIN; refer to Accessing Protected Menus
on the Operator's Manual for your machine.
3.
In the Service Menu, navigate to the H
M
.
ENU
4.
Scroll down to the service symbol
Note:
If service is currently due, the first icon
shows N
OW
5.
Below the first icon is the service interval item
(time interval, e.g. 250, 500, etc.)
Note:
Service interval is a protected menu item.
g028522
6.
Highlight the service interval and press the right
button.
7.
When the new screen appears, confirm R
S
H
ERVICE
8.
Select Y
ES
9.
After you select Y
and reverts back to the Service Hours selections.
Setting the Blade Count
1.
In the Settings Menu, scroll down to Blade
Count.
2.
Press the right button to change the blade count
between 8 or 11 blade reels.
Setting the Height of Cut (HOC)
1.
In the Settings Menu, scroll down to HOC.
2.
Press the right button to select HOC.
3.
Use the center and right button to select the
appropriate HOC setting. (If the exact setting is
not displayed, select the nearest HOC setting
from the list displayed).
4.
Press the left button to exit HOC and save the
setting.
Setting the Front and Rear Reel
Speeds
Although the front and rear reel speeds are calculated
by inputting the number of blades, mow speed and
HOC into the InfoCenter, the setting can be manually
31
M
ROTECTED
ENU
.
—A
Y
S
?
OURS
RE
OU
URE
(center button) or N
(left button).
O
the interval screen clears,
ES
and press
OURS
.
ESET
Advertisement
Table of Contents
