Toro 03956 Operator's Manual page 23

Key Switch
The key switch (Figure
O /P , and S
N REHEAT TART
Power-takeoff (PTO) Switch
When the PTO switch is engaged, the machine is in
M mode, which allows you to drive up to 13 km/h
OW
(8 mph) when the maximum speed is not limited.
When the PTO switch is not engaged
machine is in T
RANSPORT
to drive up to 16 km/h (10 mph) when the maximum
speed is not limited.
Note:
Use the protected menus in the InfoCenter to
set the maximum speed for each mode.
Figure 41
1. Disengaged
Parking Brake
To engage the parking brake,
switch forward on the console. The red light on the
switch turns on when it is set. To release the parking
brake, pivot the switch backward.
Activating the parking-brake switch causes the traction
to automatically decelerate, regardless of traction
pedal position, and engage the parking brake as soon
as the machine comes to a stop.
Once the engine has been shut off and the machine is
not moving, the parking brake engages, regardless of
parking-brake switch position.
Lower Mow/Raise Control Lever
This lever (Figure 39) raises and lowers the cutting
units.
To lower the cutting units, push the lever forward.
When the PTO switch is E
M mode, and the cutting units will start spinning
OW
when lowered.
Note:
Ensure that you lower the cutting units after
the PTO switch has been engaged to start the cutting
39) has 3 positions: O
.
(Figure 41), the
mode, which allows you
2. Engaged
(Figure 39) pivot the
, the machine is in
NGAGED
units. When you lower the cutting units before the
PTO switch is engaged, they do not start spinning.
,
FF
To fully raise the cutting units, pull the lever backward.
When the cutting units are raised and the PTO switch
is disengaged, the machine is in T
To partially raise the cutting units to the turnaround
position, briefly pull the lever backward.
InfoCenter
The InfoCenter LCD display shows information about
your machine, such as the operating status, various
diagnostics, and other information about the machine
(Figure 39).
The screens that display, depend on which buttons
you select. The purpose of each button may change
depending on what is required at the time.
Headlight Switch
Pivot the switch upward to turn on the headlights
(Figure 39).
Hydraulic-Filter-Restriction
g424477
Indicator
The hydraulic-filter-restriction indicator alerts you
when the hydraulic filters must be changed; refer to
Replacing the Hydraulic Filters (page
1. Hydraulic-filter-restriction indicator
Power Point
The power point
for electronic devices.
23
RANSPORT
82).
Figure 42
(Figure 43) is a 12 V power supply
mode.
g004132