Table of Contents
Advertisement
1. Lynch pin
2. Lift-arm shaft
7.
Insert the pivot yoke into the lift arm, and secure
shaft to the arm with the lynch pin and washer.
8.
Repeat steps
1
through
cutting unit.
Locking the Cutting-Unit Pivot for
Cutting Grass on a Hill Side
Lock the cutting-unit pivots to prevent the cutting units
from rotating downhill when cutting across the face of
a hill. Use the hole in the pivot yoke
the cutting unit. Use the slot for a steering cutting unit.
1. Snapper-pin positions
2. Hole (pivot yoke)
Installing the Cutting Unit Lift-Arm
Chains
Secure the lift-arm chain to the chain bracket with the
snapper pin
(Figure
29).
Note:
Use the number of chain links described in the
cutting unit Operator's Manual.
Figure 27
3. Lift arm
4. Washer
7
for the other rear
(Figure
Figure 28
3. Slot (pivot yoke)
g375239
1. Lift-arm chain
2. Chain bracket
Installing the Reel Motors
1.
Coat the spline shaft of the reel motor with clean
grease.
2.
Oil the reel motor O-ring and install it onto the
motor flange.
3.
Install the motor by rotating it clockwise so that
the motor flanges clear the bolts
28) lock
g375251
1. Reel-drive motor
4.
Rotate the motor counterclockwise until the
flanges encircle the bolts, and then tighten the
bolts.
Important:
hoses are not twisted, kinked, or at risk of
being pinched.
5.
Torque the mounting bolts to (27 to 33 ft-lb).
18
Figure 29
3. Snapper pin
(Figure
Figure 30
2. Mounting bolts
Make sure that the reel motor
g003948
30).
g004127
Advertisement
Table of Contents
