Table of Contents
Advertisement
Figure 99
1. Pump mechanism on the
brake manifold
5.
Insert the long end of a ratchet or similar object,
hold the black knob in on the manifold, and
pump the manifold 3 times. As soon as there is
substantial resistance when pumping the brake
is released.
Important:
Do not pump the manifold after it
does not pump easily. Damage could occur
if the manifold is pumped too much.
Note:
Once the pressure is built up in
the manifold, the brake will be released for
approximately 60 minutes. If needed after 60
minutes, release the brake again by pumping
the manifold.
6.
Push or tow the machine.
7.
Set the brake by pulling the black knob out or
starting the engine.
Note:
The brake automatically resets when you
start the engine and you do not need to pull the
black knob out.
8.
Close the bypass valves. Torque the valves to
11 N∙m (5 to 8 ft-lb).
Important:
Ensure that the bypass valves
are closed before you start operating the
machine. Running the engine with an open
bypass valve causes the transmission to
overheat.
g420086
2. Black knob
56
Advertisement
Table of Contents
