Toro 03956 Operator's Manual page 28

Note:
The purpose of each button may change
depending on what is required at the time. Each
button is labeled with an icon displaying its current
function.
InfoCenter Icon Description
Hours remaining until service
Reset the service hours
SERVICE DUE Indicates when scheduled service
should be performed
Engine rpm/status—indicates the
engine speed (rpm)
Hour meter
Info icon
Fast
Slow
Fuel level
Stationary regeneration is required.
The glow plugs are active.
Raise the cutting units.
Lower the cutting units.
Sit in the seat.
Parking brake is On.
The range is high (transport).
Neutral
The range is low (mow).
Engine-coolant temperature (°C or
°F)
Temperature (hot)
Symbols are often
combined to form
sentences. Some
examples are shown
below
28
The PTO is engaged.
Not allowed
Start the engine.
Shut off the engine.
Engine
Key switch
The cutting units are lowering.
The cutting units are raising.
PIN code
CAN bus
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
Switch
Release the switch.
Change to the indicated state.
Warm-up mode
Put the machine into Neutral.
Engine start is denied.
Engine shutdown
Engine coolant is too hot.