Toro 03956 Operator's Manual page 7

1. Warning—do not operate this machine unless you are trained. 4. Tipping hazard—drive slowly when turning; do not turn sharply
2. Warning—wear hearing protection.
3. Thrown object hazard—keep bystanders out of the operating
area.
CE Machines
Note:
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the Operator's Manual as
well as the conditions in which you would operate the machine to determine whether you can operate the machine in the conditions
on that day and at that site. Changes in the terrain can result in a change in slope operation for the machine. If possible, keep the
cutting units lowered to the ground while operating the machine on slopes. Raising the cutting units while operating on slopes can
cause the machine to become unstable.
1. Warning—read the Operator's Manual; do not operate this
machine unless you are trained.
2. Warning—wear hearing protection.
3. Thrown object hazard—keep bystanders away.
133-2930
while traveling fast; only drive on slopes with the cutting units
lowered; always wear a seatbelt.
5. Warning—do not park on slopes; engage the parking brake,
lower the cutting units, shut off the engine, and remove the
ignition key before leaving the machine.
6. Warning—read the Operator's Manual; do not tow the
machine.
133-2931
4. Tipping hazard—do not drive across or down slopes greater
than 15°; only drive on slopes with the cutting units lowered;
always wear a seatbelt.
5. Warning—do not park on slopes; engage the parking brake,
lower the cutting units, shut off the engine, and remove the
ignition key before leaving the machine.
6. Warning—read the Operator's Manual; do not tow the
machine.
7
decal133-2930
decal133-2931