BMW CE 04 Rider's Manual page 46

40 DISPLAYS
Possible cause:
The vehicle does not charge at
full power.
Check temperature, charging
infrastructure and charging
cable.
Possible cause:
The charging operation was
aborted at a state of charge of
below 90%.
Check state of charge.
Fault in charging
infrastructure
is lit yellow.
Fault in the charg-
ing infrastructure.
Check the charging cable
and mains connection or
use another mains con-
nection.
Possible cause:
Due to a fault in the charging
infrastructure, the charging op-
eration has been aborted or the
charging operation could not
be started.
Check charging cable and
power connection; use dif-
ferent power connection if
available.
Fault in the charging system
is lit yellow.
Fault in charging
sys. Charging not
possible. Drive care-
fully to nearest spe-
cialist workshop.
Possible cause:
Due to a fault in the vehicle, the
charging operation has been
aborted or the charging opera-
tion could not be started. The
DC/DC converter is faulty.
Turn on standby mode.
Detach the charging cable.
Wait two minutes.
Vehicle has gone to sleep.
Turn off standby mode.
Plug in charging cable.
New attempt at charging op-
eration is started.
If this occurs again, contact
a specialist workshop,
preferably an authorized
BMW Motorrad retailer.
Possible cause:
If the fault occurs while the
vehicle is in motion: The DC/
DC converter is faulty, and
the 12 V battery cannot be
recharged.
Have the malfunction
corrected as soon as possible
at a specialist workshop,