BMW CE 04 Rider's Manual page 119

with quick charger
The display shows whether
charging is single-phase 1 or
three-phase 2.
Pay attention to the displays
on the charging cable.
If LEDs 1 and 3 are lit, the
charging is interrupted be-
cause the temperature is too
high. If LED 2 is also blink-
ing, the vehicle is slowly be-
ing charged more. If LED 1 is
lit and LED 3 is blinking, the
charging is interrupted be-
cause the temperature in the
power plug is too high. The
following test steps are car-
ried out:
OE A check is carried out to see
if there is a ground wire con-
nection
The prerequisites for correct
charging are checked
To display the current state of
charge again, briefly press the
button.
MENU
If the charging time is longer
than expected, check the
configured
Chrg. curr.
.
limit
End charging procedure
Requirement
When ending the charging pro-
cedure, it is essential to fol-
low the steps below in the se-
quence described.
Requirement
If you are charging your vehi-
cle at a charging station, end
the charging procedure at the
charging station before detach-
ing the charging cable.
Turn on standby mode.
The charging cable is un-
locked at the electric scooter.
113