BMW CE 04 Rider's Manual page 116

110 BMW EPOWER
ATTENTION
No adaptation of the charge
current to the electrical grid
Risk of fire e.g. from over-
heating the domestic socket
outlet or excessive load on
the electrical grid
Before charging at domestic
socket outlets, check their
maximum power rating and
adapt the charge current
limit to the electrical grid.
Before charging at your own
domestic socket outlet for the
first time and when charging
at someone else's domestic
socket outlet, find out the per-
mitted charge current level,
e.g. from a qualified electri-
cian. If the permitted charge
current level is unknown, set
the charging current limit to
the lowest level.
The factory setting for the
charging current limit is set
to a charge current of 6 A.
Where appropriate, set the
charging current limit in the
menu
Settings
cle settings
,
settings
.
limit
,
Vehi-
,
Charging
Chrg. curr.
If the domestic socket
outlet or the charging
station supplies a deviating
charge current, the respective
lower charge current is used
for charging.
Connect the standard charg-
ing cable at the domestic
socket outlet or the Mode3
charging cable at the charg-
ing station, as applicable. If
charging at a charging station,
follow the instructions at the
charging station.
The standard charging cable
automatically carries out all
necessary test steps. If LED 1
is lit during this, the test was
successful. If LED 2 or 3 is
lit or blinks, the test was un-
successful and the charging
procedure cannot be started/
the charging cable must not
be connected to the vehicle.
The following test steps are
carried out