Table of Contents
Advertisement
E. Install the Log Assembly
Log Set Assembly: LOGS-T2 Models:
CAUTION: Logs are fragile, handle with care.
Verify whether the appliance is Natural Gas or Propane.
The placement of the rear log is different for each gas
type. See Figure 10. 3 which shows the bracket position
for Propane. Note that there is a gap between the bracket
and the vents. Compare with Figure 10.4 which shows the
bracket in position for NG. The bracket is installed so its
edge is aligned with the edge of the vents. There is no gap.
After determining gas type and noting correct position for
that type, align the bracket with the appropriate set of screw
holes and fasten it to the firebox with two screws.
Refer to Figure 10.9 and 10.10.
LOG BRAcKET MOVED TOwARD BAcK FOR PROPANE
GAP
REAR LOG
ADJuSTMENT TAB
Figure 10.9 Log Bracket Position - Propane
LOG BRAcKET MOVED FORwARD FOR NG
Figure 10.10 Log Bracket Position - NG
52
Heat & Glo • TIARII-BK-IPI, TIARII-BR-IPI, TIARII-CES-IPI Installation Manual • 2340-980_R9 • 06/15
NO GAP
LOG PLAcEMENT INSTRucTIONS
Place rear log into appliance and slide toward the rear of
the firebox until the log contacts the log bracket in the rear
of the firebox. The log should sit upright in the bracket. If
the log tends to roll forward, it may be necessary to bend
the rear log adjustment tab up slightly to prevent rear log
from moving.
Figure 10.11 Place Log #1
Place left and right logs into recesses cut out for them on the
left and right side of the burner. Log installation is complete.
#2
Figure 10.12 Place Log #2 and Log #3
#1
#1
#3
Advertisement
Table of Contents
