Punching Does Not Take Place; The Stapling Position Or Punch Position Is Not Correct; Folding Does Not Take Place - Sharp MX-M753 Operation Manual

Problem
Punching does not
take place.
The stapling position
or punch position is
not correct.
Folding does not take
place.
Stapling position is
not correct (including
saddle stitch).
Point to check
Does a message appear instructing you
to check the punch module?
Is a different size of paper mixed in?
Is a paper size that cannot be punched
included in the print job?
Is the tray selected in the printer driver
set to a paper type that cannot be
punched?
Have functions been disabled by the
administrator?
Is the stapling position set correctly?
Are the punching positions set
correctly?
Did the administrator enable the
"Disabling of Duplex" setting?
Are you using a paper type that has a
specific front and reverse side?
The desired staple mode is not
selected.
The paper is not loaded in the correct
position.
The paper is not loaded face up.
Dispose of punch scraps.
☞
1. BEFORE USING THE MACHINE
AND SADDLE STITCH
Punching is not possible when different widths of paper
are mixed together. To perform mixed size punching,
use paper of the same width and select the [Same
Width] setting. When copying, select [Same Width] for
[Mixed Size Original] in the special modes.
For the paper sizes that can be punched, see
"SPECIFICATIONS" in the Safety Guide.
Check the paper type settings in the machine and select
a tray that has paper that can be used for punching*.
Click the [Tray Status] button in "Paper Selection" on
the [Paper] tab of the printer properties window and
check the paper type setting of each tray.
* Punching is not possible on labels, tab paper, and
transparency film. In addition, if "Disable Punch" is
selected in the user type, punching will not be
possible.
Check with your administrator.
Some functions may have been disabled in the system
settings (administrator).
Check the stapling position setting.
☞
2. COPIER "OUTPUT" (page 2-32)
Check the punch position settings.
☞
2. COPIER "OUTPUT" (page 2-32)
The folding function cannot be used when "Disabling of
Duplex" is enabled in the system settings
(administrator). Check with your administrator.
The folding function cannot be used with pre-printed
paper, letterhead paper, or other paper that has a
specific front and reverse side.
When folding paper, use a paper type such as plain
paper that does not have specific a front and reverse
side.
Select the desired staple mode at the operation panel of
the inserter.
☞
1. BEFORE USING THE MACHINE
OPERATION OF THE
Load the paper correctly.
☞
1. BEFORE USING THE MACHINE
inserter" (page 1-65)
Paper must be loaded face up in the inserter tray.
☞
1. BEFORE USING THE MACHINE
inserter" (page 1-65)
8-55
TROUBLESHOOTING
Solution
"FINISHER
FINISHER" (page 1-50)
"MANUAL
INSERTER" (page 1-63)
"Using the
"Using the
Contents