Punching Does Not Take Place; The Stapling Position Or Punch Position Is Not Correct; Sheets Output To The Delivery Tray Of The Finisher Are Scattered; The Stapled Sheets Are Scattered - Sharp MX-M564N Operation Manual

Problem
Stapling does not take
place.
Punching does not
take place.
The stapling position
or punch position is
not correct.
Sheets output to the
delivery tray of the
finisher are scattered.
The stapled sheets are
scattered.
Point to check
Is the paper type setting of the tray
selected in the printer driver set to a
paper type that cannot be stapled?
Have functions been disabled by the
administrator?
Does a message appear instructing you
to check the punch module?
Is a different size of paper mixed in?
Is a paper size that cannot be punched
included in the print job?
Is the tray selected in the printer driver
set to a paper type that cannot be
punched?
Have functions been disabled by the
administrator?
Is the stapling position set correctly?
Are the punching positions set
correctly?
Have the output sheets got folded?
Have the output sheets got folded?
Check the paper type settings in the machine and select
a tray that has paper that can be used for stapling*.
Click the [Tray Status] button in "Paper Selection" on
the [Paper] tab of the printer properties window and
check the paper type setting of each tray.
* Stapling is not possible on labels, tab paper,
transparency film, glossy paper or envelopes. In
addition, if "Disable Staple" is selected in the user
type, stapling will not be possible.
Check with your administrator.
Some functions may have been disabled in the system
settings (administrator).
Dispose of punch scraps.
+
1. BEFORE USING THE MACHINE
MODULE" (page 1-62)
Punching is not possible when different widths of paper
are mixed together. To perform mixed size punching,
use paper of the same width and select the [Same
Width] setting. When copying, select [Same Width] for
[Mixed Size Original] in the special modes.
For the paper sizes that can be punched, see
"SPECIFICATIONS" in the Quick Start Guide.
Check the paper type settings in the machine and select
a tray that has paper that can be used for punching*.
Click the [Tray Status] button in "Paper Selection" on
the [Paper] tab of the printer properties window and
check the paper type setting of each tray.
* Punching is not possible on labels, tab paper,
transparency film, glossy paper and envelopes. In
addition, if "Disable Punch" is selected in the user
type, punching will not be possible.
Check with your administrator.
Some functions may have been disabled in the system
settings (administrator).
Check the stapling position setting.
+
2. COPIER "OUTPUT" (page 2-31)
Check the punch position settings.
+
2. COPIER "OUTPUT" (page 2-31)
If the front and back side of the sheets in the paper feed
tray have been reversed, in some cases it can be
improved.
If the front and back side of the sheets in the paper feed
tray have been reversed, in some cases it can be
improved.
8-50
TROUBLESHOOTING
Solution
"PUNCH
Contents