Sharp MX-M753 Operation Manual page 861

Problem
The scanned image is
black and white.
JPEG was selected for
the file type but the file
was created as a TIFF
file.
The image is too light
or too dark.
(When using PC
Scan.)
Point to check
Are Internet fax or fax destinations
included?
Is the color mode set to [Mono2]?
Is the threshold value suitable?
Are the brightness and contrast settings
suitable?
Use the [Start] key.
If Internet fax or fax destinations are included, scanning
will only take place in black and white.
Change the color mode to [Full Color] and then
press the [START] key.
When [JPEG] is selected for the file type and the image
is scanned in Mono 2, the file will be created as a TIFF
file.
Check the "B/W Threshold" setting.
When scanning from the TWAIN driver with [Mono 2
gradation] selected from the [Color Mode] of the
"Custom Settings" window, check the "B/W Threshold"
setting. A large threshold value makes the image darker
and a small threshold value makes the image brighter.
To adjust the "B/W Threshold" automatically, click the
[Auto Threshold] button on the [Image] tab of the
"Custom Settings" window.
When the brightness and contrast settings are not
suitable (for example, the scanned image is too bright),
click the [Auto Brightness / Contrast Adjustment] button
on the [Color] tab of the "Custom Settings" window. You
can also click the [Brightness / Contrast] button to set
the brightness and contrast while viewing the scanned
image.
8-42
TROUBLESHOOTING
Solution
Contents