Punching Does Not Take Place; The Stapling Position Or Punch Position Is Not Correct - Sharp MX-M850 User Manual

Problem
Punching does not
take place.
The stapling position
or punch position is
not correct.
Paper folding does not
take place.
Paper is folded in the
wrong place.
Point to check
Does a message appear instructing you
to check the punch module?
Is a different size of paper mixed in?
Is a paper size that cannot be punched
included in the print job?
Is the tray selected in the printer driver
set to a paper type that cannot be
punched?
Have functions been disabled by the
administrator?
Is the stapling position set correctly?
Are the punching positions set
correctly?
Is the orientation of inserting the paper
correct?
(when using the inserter)
Are you using a paper size that cannot
be folded?
Was the paper loaded in the wrong
orientation?
Dispose of punch scraps.
☞
"DISCARDING PUNCH WASTE" in the
Maintenance Guide
Punching is not possible when different widths of paper
are mixed together. To perform mixed size punching,
use paper of the same width and select the [Same
Width] setting. When copying, select [Same Width] for
[Mixed Size Original] in the special modes.
For the paper sizes that can be punched, see the
specifications in the Safety Guide.
Check the paper type settings in the machine and select
a tray that has paper that can be used for punching*.
Click the [Tray Status] button in "Paper Selection" on
the [Paper] tab of the printer properties window and
check the paper type setting of each tray.
* Punching is not possible on labels, tab paper,
transparency film, and envelopes. In addition, if
"Disable Punch" is selected in the user type, punching
will not be possible.
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
Check the stapling position setting.
☞
MANUAL FINISHING MODE
☞
"OUT PUT" in the Copier Guide
Check the punch position settings.
☞
MANUAL FINISHING MODE
☞
"OUT PUT" in the Copier Guide
Check the orientation of the paper.
☞
INSERTER
Only specific paper sizes can be folded. Make sure that
you are attempting to fold an allowed paper size.
☞
FOLDING UNIT
Make sure that the paper is loaded in the correct
orientation for folding.
☞
MANUAL FINISHING MODE
☞
"OUT PUT" in the Copier Guide
95
Solution
(page 65)
(page 65)
(page 62)
(page 61)
(page 65)