Table of Contents
Advertisement
Installation manual
Installation
Unwrap the cabinet and remove the shipping braces. Lift up cabinet and remove shipping base
Positioning and Levelling
To position the cases:
1. If the plinth surface is not level, determine where the highest point of the plinth is, and position the case allocated
to this position first.
2. Snap a chalk line on the floor to use as a guide for positioning the front of the cases in the line-up. Determine the
position of the case and choose a part of the case that will relate to the chalk line.
3. Adjust the case height using the adjustable feet (if fitted) or metal shims (do NOT use timber) to ensure the case
is level to within +/- 1.5mm from front to back and side to side and chassis of case is NOT twisted. Maximum
30mm adjustment.
_________________________________________________________________________________________________________________________
Page 5
Information in this manual is to be followed in conjunction
with specifications, work practices and regulations of the
customer, installing company and relevant industry.
Figure 2
Levelling feet adjustment
Ensure the lifting capacity of the trolley, etc is sufficient
for the case. Refer to the product engineering data tables
at the front of this manual for case weights and Risk
Analysis (page 22).
Figure 3:-
Levelling feet adjustment
MJPE multideck and SMD/SME Low Height Multideck
NOTE
CAUTION
Hussmann
Advertisement
Table of Contents
