Attaching Kickplates - Hussmann Multideck Meat 3750 Installation Manual

Installation manual

Attaching Kickplates

(This should be done after final Installation of Refrigeration and Drainage connections)
•
Use hex screws 6.3 x 19mm to fix the kickplate support to the base. (These parts are in the accessories box).
•
Do NOT fix the kickplate support to the base too tightly. It should be able to slip up and down through the oblong
hole. This will enable the kickplate to be moveable and it will naturally sit correctly in relation to the floor.
•
Cut the gasket 45° and fit to the lower kickplate panel.
_________________________________________________________________________________________________________________________
Page 11
Figure 13:- Kickplate support assembly
Figure 14:- Kickplate assembly
MJPE multideck and SMD/SME Low Height Multideck
Hussmann