Installation manual
Joining the Cases
Ensure cases are sealed before joining them to other cases
To join the cases
1. Align the canopy by inserting the "multiplexing rods" into the aluminium canopy decoration panel
2. Draw up the required case tightly against the case already in position
________________________________________________________________________________________________________________________
Page 8
Do not walk or sit on cases.
Figure 7:-
Insert multiplexing rods for joining
Case joining bolts should only be used, with
care, at the final pulling-up stage.
MJPE multideck and SMD/SME Low Height Multideck
CAUTION
CAUTION
Hussmann