Installation manual
Commissioning
Cleaning case
•
Remove the PVC protective coating on stainless steel, where applicable
•
Remove any residue, silicon or tape marks with a cloth moistened with rubbing alcohol
•
Remove all debris from in and around the case
•
Wipe case with a clean, damp cloth, if necessary
Starting up
•
Check supply power is ready and correct voltage. (by Licensed Person)
•
Confirm correct operation of RCD (if fitted) (by Licensed Person)
Turn case power on
Start up checks – by qualified persons only
•
Ensure that the drain trap is installed the right way up (refer to figure 7: drain trap orientation in the section
installing the waste drain)
•
Check that all fans and lights (and light RCDs, if installed) are working correctly.
•
Check the anti sweat circuit, ensuring the thermostat is set correctly.
•
Set expansion valves and EPRs as per Product Engineering Data – Available from Hussmann.
•
Approximately 24 hours after start-up, check that the case is at correct operating temperature (refer the Product
Engineering Data).
________________________________________________________________________________________________________________________
Page 18
MJPE multideck and SMD/SME Low Height Multideck
Hussmann