Yamaha FJR 1300 AE 2014 Service Manual page 675

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
Diagnostic
code No.
08 Lean angle sensor
• Upright
• Overturned
09 Fuel system voltage
(battery voltage)
13 Throttle position sensor
signal 2
• Fully closed position
• Fully open position
14 Accelerator position sen-
sor signal 1
• Fully closed position
• Fully open position
15 Accelerator position sen-
sor signal 2
• Fully closed position
• Fully open position
16 Front wheel vehicle speed
pulses
20 Sidestand switch
• Stand retracted
• Stand extended
Item
Lean angle sensor output
voltage
0.4–1.4
3.7–4.4
Approximately 12.0
9–23
94–108
12–22
97–107
10–24
95–109
Front wheel speed pulse
0–999
ON
OFF
Meter display
9-8
(ECU)
Procedure
Remove the lean angle
sensor and incline it more
than 65 degrees.
Set the start/engine stop
switch to " ", and then
compare the actually mea-
sured battery voltage with
the meter display value. (If
the actually measured bat-
tery voltage is low, re-
charge the battery.)
Check with throttle valves
fully closed.
Check with throttle valves
fully open.
Check with throttle grip ful-
ly closed position.
Check with throttle grip ful-
ly open position.
Check with throttle grip ful-
ly closed position.
Check with throttle grip ful-
ly open position.
Check that the number in-
creases when the front
wheel is rotated. The num-
ber is cumulative and
does not reset each time
the wheel is stopped.
Extend and retract the sid-
estand (with the transmis-
sion in gear).