Checking The Rear Wheel; Maintenance Of The Rear Wheel Sensor And Sensor Rotor; Assembling The Rear Wheel - Yamaha FJR 1300 AE 2014 Service Manual

1
d. Remove the wheel sensor rotor.
e. Remove the wheel bearings "1" with a gener-
al bearing puller.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS22090

CHECKING THE REAR WHEEL

1. Check:
• Rear wheel axle
• Rear wheel
• Wheel bearings
• Oil seal
Refer to "CHECKING THE FRONT WHEEL"
on page 4-24.
2. Check:
• Tire
• Rear wheel
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-17 and "CHECKING THE WHEELS" on
page 3-17.
3. Measure:
• Radial wheel runout
• Lateral wheel runout
Refer to "CHECKING THE FRONT WHEEL"
on page 4-24.
Radial wheel runout limit
1.0 mm (0.04 in)
Lateral wheel runout limit
0.5 mm (0.02 in)
2
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS22200
MAINTENANCE OF THE REAR WHEEL
SENSOR AND SENSOR ROTOR
ECA3P6D008
NOTICE
• Handle the ABS components with care
since they have been accurately adjusted.
Keep them away from dirt and do not sub-
ject them to shocks.
• The rear wheel sensor cannot be disassem-
bled. Do not attempt to disassemble it. If
faulty, replace with a new one.
• Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the wheel sensor rotor.
• Do not drop or shock the wheel sensor or
the wheel sensor rotor.
1. Check:
• Rear wheel sensor
Refer to "MAINTENANCE OF THE FRONT
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-25.
2. Check:
• Rear wheel sensor rotor
▲▲▲
Refer to "MAINTENANCE OF THE FRONT
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-25.
3. Measure:
• Rear wheel sensor rotor deflection
Refer to "MAINTENANCE OF THE FRONT
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-25.
EAS22140

ASSEMBLING THE REAR WHEEL

ECA3P6D003
NOTICE
• Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the wheel sensor rotor.
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
1. Install:
• Bearing "1"
4-33
REAR WHEEL
Wheel sensor rotor deflection
limit
0.14 mm (0.0055 in)
Installed depth of bearing "a"
3.5–4.5 mm (0.14–0.18 in)