Yamaha FJR 1300 AE 2014 Service Manual page 133

1. SCU (suspension control unit)
2. Storage compartment
3. Yamaha diagnostic tool lead
4. Yamaha diagnostic tool coupler
5. License plate light lead
6. Tail/brake light assembly lead
7. Seat lock cable
8. SCU lead
A. Route the Yamaha diagnostic tool lead to the rear
of the positioning ribs and under the band that is
used to secure the SCU (suspension control unit).
B. Install the protective cap onto the Yamaha
diagnostic tool coupler, and then install the coupler
onto the projection on the storage compartment.
C. Route the tail/brake light assembly lead and
license plate light lead between the rib and the U-
lock holder on the rear fender, making sure that the
leads are not routed on top of the holder.
D. Fasten the tail/brake light assembly lead and
license plate light lead with the holder.
E. Route the tail/brake light assembly lead and
license plate light lead between the ribs on the rear
fender.
F. Route the Yamaha diagnostic tool lead over the
SCU lead.
2-62
CABLE ROUTING