Yamaha FJR 1300 AE 2014 Service Manual page 248

6. Turn the main switch to "ON" while operating
the brake lever and the brake pedal simulta-
neously.
TIP
• This check cannot be performed unless both
the brake lever and the brake pedal are oper-
ated simultaneously when the main switch is
turned to "ON".
• Do not push the " " side of the start/engine
stop switch when turning the main switch to
"ON", otherwise the operation test will not be-
gin.
7. Check:
• Hydraulic unit operation
When the main switch is turned to "ON", a
single pulse will be generated in the brake le-
ver "1". After the pulse is generated in the
brake lever, it is generated in the brake pedal
"2" twice.
TIP
A single pulse will be felt in the brake lever once,
then in the brake pedal twice. The second per-
son should confirm that the rear brake force is
released during the second pulse in the brake
pedal, third pulse overall, by manually applying
force to rotate the rear wheel. If the rear brake
force is released during the second pulse in the
brake pedal, the second person will be able to
rotate the rear wheel for 0.1 second.
1
ABS (ANTI-LOCK BRAKE SYSTEM)
ECA3P6D019
NOTICE
• Check that the pulse is felt in the brake le-
ver once, and then in the brake pedal twice.
• If the pulse is felt in the brake pedal before
it is felt in the brake lever, check that the
brake hoses and brake pipes are connected
correctly to the hydraulic unit assembly.
• If the rear brake force is not released during
the second pulse in the brake pedal, but
during the pulse in the brake lever or during
the first pulse in the brake pedal, check that
the brake hoses and brake pipes are con-
nected correctly to the hydraulic unit as-
sembly.
• If the pulse is hardly felt in either the brake
lever or brake pedal, check that the brake
hoses and brake pipes are connected cor-
rectly to the hydraulic unit assembly.
• If the operation of the hydraulic unit is normal,
Hydraulic unit operation test 2
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
1. Place the vehicle on the centerstand so that
2. Check:
• Engine stop due to sidestand operation
▼ ▼▼▼
a. Shift the transmission into gear and extend
b. Turn the main switch to "ON".
c. Push the " " side of the start/engine stop
2
d. Turn the main switch to "OFF".
4-71
delete all of the fault codes.
WARNING
the rear wheel is elevated.
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
the sidestand.
switch, and check that the starter motor does
not operate. If the starter motor operates,
check the ignition circuit cut-off system.
Refer to "ENGINE STOPPING DUE TO SID-
ESTAND OPERATION" on page 8-3.
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼