Siemens 7MB3000 Series Operating Instructions Manual page 79

4. Remove the following cables:
– Power cable to the analyzer module printed circuit board and power supply unit
– 12-pin ribbon cable (CAN) to the analyzer module printed circuit board and the
– If applicable, 26-pin ribbon cable to the analyzer module printed circuit board or the
5. Loosen the eight screws
6. Swivel the analyzer module
7. If you are not installing and connecting a new analyzer module:
Fasten the blank plates over the two slots using eight Torx screws
torque of 0.8 Nm.
8. Close the door of the housing with the six screws
Tighten the screws
Wall-mounted device
Operating Instructions, 07/2023, A5E31930403-AB
Installing / removing and connecting analyzer and option modules
processing unit
analog output adapter card and the option module OM 2.1 or OM 2.2
③
②
on the door with a torque of 3.5 Nm.
7.9 Removing OXYMAT 7, high-temperature version
on the housing floor and the two Torx screws on the rear wall.
⑥
forward and remove it from the wall housing.
②
③
in each case with a
.
79