Siemens 7MB3000 Series Operating Instructions Manual page 71

4. Loosen the eight Torx screws
5. Check the flat seal
Replace the flat seal if it is damaged or porous.
6. Swivel the analyzer module
7. Secure the analyzer module
– Use eight Torx screws on the base of the housing
– Use two Torx screws on the rear panel with a torque of 2.5 Nm.
8. Connect the gas lines, see section "Gas connections (Page 91)".
Wall-mounted device
Operating Instructions, 07/2023, A5E31930403-AB
Installing / removing and connecting analyzer and option modules
7.5 Installing OXYMAT 7, high-temperature version
③
and remove the two blank plates at slots 1 and 2.
④
for damage.
⑥
forward and insert it into the wall housing
⑥
in the slot as follows:
①
③
with a torque of 0.8 Nm.
.
71