Siemens 7MB3000 Series Operating Instructions Manual page 108

Connecting the device
8.2 Electrical connections
Overview
①
②
③
Figure 8-9
Procedure
1. Undo the six screws
2. Remove the shielding plate
3. Strip the end of signal cable to a length of approx. 1 cm.
4. Loosen the union nut from the respective cable gland
mounted device.
5. Insert the signal cable through this cable gland
6. Insert the stripped conductors of the signal cable into the terminal block in accordance with
the terminal assignment.
108
Door screws
Shielding plate
Cable glands for signal lines (7 units)
Wall-mounted device, connecting signal cables
①
and open the door of the wall-mounted device.
②
on the right side panel. To do this loosen the screws.
③
.
Operating Instructions, 07/2023, A5E31930403-AB
③
on the underside of the wall-
Wall-mounted device