Remove The Solid-State Drive (Ssd) Module - Lenovo V14 Gen 4 i Hardware Maintenance Manual

Screw specifications
M2 x L3.5
Go to https://support.lenovo.com/partslookup
part:
Battery pack

Remove the solid-state drive (SSD) module

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 38
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw then remove the SSD by pulling it away from the slot.
Figure 12. Remove one screw then remove the SSD by pulling it away from the slot
Screw specifications
M2 x L2.8
Step 3. Remove the SSD thermal pad.
Figure 13. Remove the SSD thermal pad
40
Hardware Maintenance Manual
Number of screws
2
to look up the Lenovo part number of the following replacement
Number of screws
1