Screw specifications
M2 x L3.5
Go to
https://support.lenovo.com/partslookup
part:
Battery pack
Remove the solid-state drive (SSD) module
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Remove one screw and then remove the SSD by pulling it away from the slot.
Figure 6. Remove the SSD
Screw specifications
M1.6 x L1.7
Step 3.
Remove one screw and then remove the SSD bracket from the SSD.
Figure 7. Remove the SSD bracket
Screw specifications
M1.6 x L1.7
Step 4.
Remove the SSD mylar.
30
Hardware Maintenance Manual
Number of screws
3
to look up the Lenovo part number of the following replacement
Number of screws
1
Number of screws
1