Remove the thermal module (for Lenovo V15 G4 IAN)
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 77
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Remove three screws and then release the cable from the cable guide.
Figure 87. Remove three screws and then release the cable from the cable guide
Screw specifications
M2 x L5
Step 3.
Loosen four screws and then remove the thermal module.
Figure 88. Loosen four screws and then remove the thermal module
Go to
https://support.lenovo.com/partslookup
part:
Thermal module
Remove the I/O board
Make sure the following FRU (or CRU) have been removed.
"Remove the lower case" on page 77
Number of screws
3
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
83