Remove The Solid-State Drive (Ssd) Module - Lenovo ThinkBook 15p Gen 2 i Hardware Maintenance Manual

Remove the solid-state drive (SSD) module

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 30
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove the SSD thermal pad.
Figure 6. Remove the SSD thermal pad
Screw specifications
M2 x L3
Step 3. Remove one screw from the SSD stand off.
Figure 7. Remove one screw from the SSD stand off
Screw specifications
M2 x L3
Step 4. Remove the SSD by pulling it away from the slot.
32
Hardware Maintenance Manual
Number of screws
1
Number of screws
1