Remove The Upper Case - Lenovo V14 Gen 4 i Hardware Maintenance Manual

Figure 31. Disconnect the EDP cable from the system board
Step 3. Rotate the LCD unit to an angle of more than 90 degrees and place the computer on a flat surface
as shown. Remove four screws and then remove the LCD module.
Figure 32. Remove four screws and then remove the LCD module
Screw specifications
M2.5 x L5

Remove the upper case

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 38
"Remove the battery pack" on page 39
"Remove the solid-state drive (SSD) module" on page 40
"Remove the solid-state drive (SSD) stand off" on page 41
"Remove the speakers" on page 42
"Remove the Wi-Fi card" on page 42
"Remove the heat sink (for Lenovo V14 G4 AMN)" on page 43
Number of screws
4
.
Chapter 4 Removing a FRU or CRU
51